Step Three Operate the sprayer, Review safety | North Star MTBSL

Operation - Using the Sprayer (continued)

Step Three: Operate the sprayer.

WARNING

ALWAYS wear personal protective equipment as directed on the chemical label when spraying.

Long pants and sleeves, chemical-resistant gloves, and eye protection are strongly recommended. Additional protective gear may be required depending on the particular pesticide.

1.	Review safety	Review the “Operation – Important Safety Information” related to Chemical
	information	Application Safety and ATV Vehicle Handling Safety provided in this manual.
2.	Wear personal	Wear personal protective equipment as directed on the chemical label.
	protective
	equipment
3. Close boom valves		Close boom valves to prevent accidental spray release.
		Closed boom
		valves

4. Turn on power	Turn on the power to the sprayer.
	1. Verify the remote switch is connected to the pump power cord.
	2. Turn the remote switch to the “ON” position.
	Note: The pump will start automatically when power is turned on. The pump
	will cycle on and off as needed to retain pressure in the hose.
5. Begin agitation if	Some formulations of liquid pesticides do not remain in solution and should
needed	be agitated to maintain a uniform mix.
	An optional agitator (Item #28520) accessory is available for use with this
	sprayer and should be used when spraying pesticides classified as “flowable”
	(“F” or “L”), “wettable powder” (“WP” or “W”), “emulsion” (“EC” or “E”),
	“microencapsulated” (“M”), or water dispersible granules (“WDG” or “DF”).
	(See pesticide label to determine its classification.)
	Contact NorthStar Customer Service at 1-800-270-0810 for any questions
	about the appropriate use of the sprayer and/or optional accessories.

27

Image 27

North Star MTBSL owner manual Step Three Operate the sprayer, Review safety, Begin agitation if

Contents

Mtbsl Hazard Signal Word Definitions Table of Contents Spraying Pesticides Intended Use Chemical Application Safety Summary of Important Safety InformationDuring Assembly General Chemical Safety Towing Safety Chemical accident procedures Differently with filled sprayer attached Unpacking Closely inspect all contents in the shipping carton Following items are found in the manual bag Unpacking the Manual Bag Step Three Attach the cart base to the sprayer AssemblyStep One Attach the tongue to the cart base Step Two Attach the hitch mount to the tongue Step Five Attach boom supports and boom bracket to cart base Step Four Attach wheels to cart base Step Six Attach boom arms to the boom bracket Step Ten Attach drain cap to tank Step Seven Attach gun hose to spray gun and pumpStep Eight Attach hose guide to tank Step Nine Attach gun clips to tank Step Twelve Connect boom valve to boom nozzles Step Eleven Install boom valve to pump Step Thirteen Attach sprayer to vehicle Step Fourteen Connect remote switch to vehicle battery Connected to the battery Working condition Step Fifteen Check and test completed assemblyCheck and test completed assembly Check assembly Machine Components General Chemical Safety Operation Important Safety Information After Spraying Chemical Application SafetyBefore Spraying During Spraying Towing Safety Inhalation Important safety rules Operation Preparing the Sprayer for Each UseInspect Inspect and test the sprayer thoroughly Repair Operation Using the Sprayer Step One Assess wind conditions and clear work areaSpray because the wind is too strong Fill the sprayer using the following steps Step Two Fill the sprayerEnsure tank is flushed of all chemicals from prior uses Fill tank Check drain Review safety Step Three Operate the sprayerBegin agitation if Adjust nozzle Squeeze trigger & To spray, squeeze the gun triggerUnfold one or both boom arms as required Ensure uniform coverage Ensure correct spray pattern Launder Step Four Clean sprayer and decontaminate after useDrain tank Decontaminate Add antifreeze StoragePreparing for storage Removing from storage Before attempting to service the sprayer Troubleshooting Any Questions, Comments, Problems or Parts Orders Specifications Part# Description Model Qty Exploded View 28517/28518 Rev. L Height Appendix a Broadcast Spray Calibration TablesApproximate flow from one nozzle Spray Pressure