Installation
Rack-Mount Subsystem Assembly
16
2To aide in support bracket installation, remove the rack cabinet side panels.
3Locate the two support brackets. Mount the two brackets to the rack cabinet
verticals using the four screws, four washers, and four caged nuts provided
for each bracket. Refer to detail “A” in the illustration on the previous page.
NOTE: The caged nuts are secured into the rack cabinet vertical slots by inserting
one side of the nut into the slot and squeezing while pressing the opposite
side in until it snaps into place.
4Remove the two (2) upper enclosure case screws as depicted below on the
right side of the subsystem cabinet.
NOTE: The enclosure is attached to the support bracket only on the right side.
5Slide the subsystem cabinet into the cabinet with the subsystem riding on top
of the support brackets.
6Align the two upper case screw holes with those provided in the support
bracket on the right side.
7Secure the subsystem cabinet to the right hand rail using the two (2) screws
previously removed.
8Continue with the component installation on the next page.
Rail is installed to
the front and rear
rack cabinet verticals.
8-32 Pan
Head Screws