Installation
Component Installation
18
6Fully seat the drive by applying pressure with your thumb to the front of the
drive.
7Press the Drive Latching Clips until they “snap” into place. The drive is now
locked into position.
8Install the remaining drives repeating steps 3 through 7, until all the drives
have been installed, as desired.
NOTE: Verify that the power switch on the CR8e is in the OFF position (O).
9Connect one end of the power cord to the power connector on the rear panel
and the other end to a three-hole grounded outlet or power strip. A UPS is
recommended.
10 Refer to the “Cabling Configuration” on page 20 to complete the data cable
connections if you are using the AM RAID Controller card. If you are using
the Ultra S2S RAID Controller, refer to the nStor Ultra S2S RAID Controller
and PC Utilities User’s Guide for information about cabling configurations.
Lower (right) bay,
four drive slots
Drive Label
Component side
Populate drive bays from
the lower (right) slot first.
Upper (left) bay,
four drive slots