Using the CR8e
SAFTE CHAIN ID
50
SAFTE CHAIN ID
This option allows the administrator to establish the intercabinet SAF-TE
communication to support a master and slave cabinets. The master cabinet can
report component failure for both the master cabinet and up to two slave cabinets
to the AdminiStor Storage Management software. Each cabinet’s individual OCP
will function normally for that cabinet’s components.
Once the slave cabinets have been established, the administrator must use the slave
cabinet’s OCP to manually take that slave cabinet SAF-TE card off bus, refer to
“SCSI ID Menu” on page 46.
1Choose the SAFTE CHAIN ID selection and press the Enter button.
2Use the up/down arrow buttons and choose between the options: None,
Master, Slave 1, and Slave 2, then press the Enter button.
NOTE:
Choose “NONE” when the cabinet is used in a stand-alone configuration
or the master/slave option is not desired.
3You will be prompted to cycle the power on the CR8e for the changes to take
effect.
MENU ENTER ESCAPE
MASTER
NONE
SLAVE 1
SLAVE 2

nStor

MENU ENTER ESCAPE

nStor

SCSI ID MENU
HEAT THRESHOLD
SAFTE CHAIN ID
CHANGE PASSCODE