Installation
Fast Wide SCSI Mode 31
3Turn on the power to the CR8e. After the power-on self-test has completed,
Status and Channel Mode LEDs will be solid green.
4Access the Options menu on the Operator Control Panel and choose the
SAFTE CHAIN ID selection. Choose the “None” selection, refer to “SAFTE
CHAIN ID” on page 50.
5After setting the cabinet identifications you must power cycle the subsystem.
Observe normal power cycling precautions by waiting a minimum of five (5)
seconds before adding power again.
This will reset the SCSI IDs to a default setting that prevents a SCSI ID
conflict under normal conditions.
6Power up your computer system and run the configuration program.
This completes the hardware installation.