Olitec RW400SG manual 5.4.1 LAN, 5.4.2 WAN

5.4.1 LAN

You can configure the IP parameters of LAN on this page.

Figure 5-3: LAN

¾MAC Address - the physical address of the router, as seen from the LAN. The value can't be changed.

¾IP Address - Enter the IP address of your router in dotted-decimal notation (factory default: 192.168.1.1).

¾Subnet Mask - An address code that determines the size of the network. Normally use 255.255.255.0 as the subnet mask.

Note:

a.If you change the IP Address of LAN, you must use the new IP Address to login the router.

b.If the new LAN IP Address you set is not in the same subnet, the IP Address pool in the DHCP sever will not take effect, until they are re-configured.

c.If the new LAN IP Address you set is not in the same subnet, the Virtual Server and DMZ Host will change accordingly at the same time.

5.4.2 WAN

You can configure the WAN port parameters on this page.

First, please choose the WAN Connection Type (Dynamic IP/Static IP/PPPoE/802.1x + Dynamic IP/802.1x + Static IP) to the Internet. The default type is PPPoE. If you aren’t given any login parameters (fixed IP Address, logging ID, etc), please select Dynamic IP. If you are given a fixed IP (static IP), please select Static IP. If you are given a user name and a password, please select PPPoE. If you are not sure which connection type you use currently, please contact your ISP to obtain the correct information.

1.If you choose Dynamic IP, the router will automatically get IP parameters from your ISP. You can see the page as follows (figure 5-4):

- 13 -