Olivetti 120D, 150D manual Making Copies, Copy Flow

5 MAKING COPIES

This chapter describes basic copying functions and some other copying functions. The copier is equipped with a 1-page memory buffer. This memory allows the copier to scan an original once only and make up to 99 copies. This feature allows for improved workflow, reduced operating noise from the copier and reduced wear and tear on the scanning mechanism. This feature provides for a higher reliability.

If the unit does not function properly during use, or if a function cannot be used, see "TROUBLESHOOTING THE UNIT" (p.62).

COPY FLOW

1Make sure that paper has been loaded in the paper tray (p.15) and check the paper size (p.14).

If paper is not loaded, see page 15. If you are using the single bypass, check the paper size and then proceed to the next step without loading paper.

2Place the original.

If you are using the original table, see "Using the original table" (p.47). If you are using the SPF, see "Using the SPF (p.48).

When copying onto A4 paper or a large size, pull out the paper output tray extension.

3Select the copy settings.

If you wish to copy using the initial settings (p.13), proceed to the next step. To set the number of copies, see page 49.

To adjust the resolution and contrast settings, see page 50. To enlarge or reduce the copy, see page 52.

To print on both sides of the paper, see page 53.

4Start copying.

Press the start () key.

If you are using the single bypass

Do not press the start ( ) key. Insert a sheet of paper into the single bypass. (Page 17)

Multiple copies are not possible using the single bypass.

46