Troubleshooting

7

Troubleshooting

EN

84

Symptom

Probable cause

Action

 

The microphone sensitivity is too low.

Set [Mic Sense] to [High] or [Middle]

 

(P.47, P.49).

Recording level too

 

This could potentially be because

 

low

Adjust the output level for the

 

the output level for the connected

 

connected devices.

 

external devices are too low.

 

 

 

 

When recording while an external

 

The connected external microphone

monaural microphone is connected,

 

is monaural.

sound will only be recorded by the

Voice files are not

 

L-channel.

[Rec Mode] is set to a monaural

Set [Rec Mode] to the stereo

recorded in stereo

 

recording mode.

recording mode (P.47, P.49).

 

[Zoom Mic] is set to the + side.

Set [Zoom Mic] to [Off] (P.47, P.50).

 

 

 

Cannot find the

Wrong folder.

Switch to the correct folder

recorded Voice File

(P.22 to P.24).

 

 

The recorder was shaken during

———

 

recording.

Noise heard during

 

The recorder was placed near a cell

 

playback

Move the recorder.

 

phone or fluorescent lamp while

 

recording or during playback.

 

Unable to erase the

The file is locked.

Unlock the file (P.47, P.49).

 

 

file

The file is read-only.

Unlock the file or cancel the read-only

 

 

setting of the file on the PC.

Unable to erase the

There is a file which cannot be

Connect the recorder to your PC and

recognized by the recorder in the

folders

erase a folder (P.67, P.69).

folder.

 

 

 

 

When the built-in speaker amps and

 

 

the like are connected there is a risk

 

 

that audio feedback will occur while

 

 

recording. It is recommended that

Noise is audible

 

you use earphones for the recording

 

monitor.

through the recording

Acoustic feedback is occurring.

monitor

 

Conduct adjustments like separating

 

 

the earphones from the microphone

 

 

further, do not point the microphone

 

 

at the earphones, lower the volume on

 

 

the recording monitor, and so on.

 

The maximum number of marks has

Erase unnecessary marks (P.35).

 

been reached.

 

 

Unable to set index

The file is locked.

Unlock the file (P.47, P.49).

marks, tempmarks

 

 

 

 

 

 

The file is read-only.

Unlock the file or cancel the read-only

 

setting of the file on the PC.