Olympus PT-022 E-13

E-13

Setting the Zoom Lever

When loading the digital

camera in the Case, fit the

projecting part of the zoom

lever of the digital camera into

the recessed part of the zoom

lever on the inside of the Case.

How to switch the power ON

The method of turning this product ON is variable depending on the

camera in use (C-760 Ultra Zoom/C-770 Ultra Zoom). See the

following procedures for details.

:•When loading the camera, confirm that the projecting

part of the zoom lever of the camera is properly set to the

recessed part of the zoom lever of the Case.

•When the setting is insufficient, the loading of the camera

becomes imperfect and it may not be possible to seal the

Case or zooming may not function. Insufficient sealing

will cause water leakage.

CAUTION

C-760 Ultra Zoom

1)

Gently turn the power switch dial knob

clockwise until it stops.

2) Turn the power switch button clockwise

and, when a click sound is heard, press

the power switch button to turn the

camera ON.

Pressing the power switch button again

turns the camera OFF.

Contents

Main Instruction Manual PT-022 Underwater Case E-1 Introduction Please read the following items before use For safe use WARNING E-2 WARNING E-3 Batteries E-4 For Prevention of Water Leakage Accidents E-5 Handling the Product E-6 E-7 Contents Contents 1.Preparations ............................................................E-9 2.Advance Check of the Case 3.Install the digital camera. E-8 4.Taking Pictures Under Water 5.Handling After Shooting 6.Maintaining the Waterproof Function 7.Appendix Page E-10 Names of the parts Note: E-11 Install the strap. Master the basic operation. Holding the Case Installation explanation E-12 How to Press the Shutter How to Use the Zoom Lever How to Use the Mode Dial Mode dial knob E-13 Setting the Zoom Lever How to switch the power ON C-760 Ultra Zoom E-14 C-770 Ultra Zoom Page E-16 Removing the TLL cable connector cap ---- How to attach the TTL cable connector cap to the case ---- E-17 Removing the hot shoe cable cap 1 3 Cleaning the TTL connector E-18 2. Advance Check of the Case Advance test before use Advance Test E-19 3. Install the digital camera. E-20 Check the operation of the camera. Load the digital camera. Open the Case. Pull up the mode dial of the case. E-21 Insertion of silica gel Set the mode dial. E-22 Seal the Case. Install the special balance weight. Check the loading status. E-23 E-24 E-25 Final Test E-26 4. Taking Pictures Under Water How to Use the Hand Strap Take pictures carefully. Confirm the picture on the LCD monitor. Quietly press the shutter lever. E-27 5. Handling After Shooting Wipe off any waterdrop. E-28 Take out the digital camera. E-29 Wash the Case with pure water. Dry the Case. E-30 6. Maintaining the Waterproof Function Remove the O-ring. Remove any sand, dirt, etc. E-31 E-32 Install the O-ring. How to Apply Grease to the O-ring E-33 Maintenance of the threaded sections on the TTL cable and TTL cable connector Maintenance of the TTL Connector Cap E-34 Replace consumable products. 1 2 E-35 7. Appendix Q & A on the use of the PT-022 E-36 E-37 E-38 E-39 E-40 After-sale Service E-41 Specifications Diver's Insurance Guide