E-21

Insertion of silica gel

Pay attention to the orientation.
Before sealing the Case, insert the accessory silica gel bag for
prevention of fogging between the bottom of the camera and the
Case. Insert the bag with the glued longer side to the inside.
:•
Insert the silica gel all the way at the specified location
and with the specified orientation. When the orientation
is not correct, the silica gel bag will be caught when the
Case is sealed and water leakage will be caused.
•
When it is tried to seal the Case with the bag inserted only
part of the way, the silica gel bag will be caught by the O-
ring and water leakage will be caused.
•
Once silica gel has been used, the moisture absorption
performance will be impaired. Always exchange the
silica gel when the Case is opened and closed
.
CAUTION

Set the mode dial.

After the digital camera has been
loaded, push down the mode dial
of the case from the upper surface
of the case and set it so that the
lower part of the mode dial of the
case on the inside of the case fits
properly onto the upper part of the
mode dial of the digital camera.
Advice •After setting the mode dial of the case, set the power of the digital
camera to 'OFF', and before sealing the case, operate the mode
dial and confirm that the mode of the digital camera is switched.