Olympus PT-022 E-16

E-16

Removing the TLL cable connector cap

TTL flash shooting by combining this case (PT-022) and the case for

FL-20 flash (optional PFL-01):

TTL cable

connector cap

Turn counter clockwise.

Remove.

Underwater

TTL cable

Insert into the

connector.

Turn the threaded section of the connector

clockwise lightly until it is stopped.

1

2

1

Remove the TTL cable connector

cap from this case.

❈

The PFL-01 can be used only

with the C-770 Ultra Zoom.

2

Connect the underwater TTL

cable connector, provided with

the PFL-01, to the TTL cable

connector on this case.

---- How to attach the TTL cable connector cap to the case ----

Make sure there is no foreign matter attached to the O-rings inside

the cap and on the TTL cable connector. To secure the cap, gently

turn it clockwise until it stops.

Gently turn the cap

clockwise until it stops.

Put the cap on the case.

:•

If the TTL cable connector cap is loose, water

penetration may result. Be sure to gently turn the cap

until it stops to make sure it is firmly secured.

Do not turn or tighten the TTL cable too hard. If it is

too tight, it may be difficult to loosen and remove it.

CAUTION

❈Refer to the optional PFL-01's instruction manual for detailed

instructions on using the TTL cable and hot shoe cable.

Contents

Main Instruction Manual PT-022 Underwater Case E-1 Introduction Please read the following items before use For safe use WARNING E-2 WARNING E-3 Batteries E-4 For Prevention of Water Leakage Accidents E-5 Handling the Product E-6 E-7 Contents Contents 1.Preparations ............................................................E-9 2.Advance Check of the Case 3.Install the digital camera. E-8 4.Taking Pictures Under Water 5.Handling After Shooting 6.Maintaining the Waterproof Function 7.Appendix Page E-10 Names of the parts Note: E-11 Install the strap. Master the basic operation. Holding the Case Installation explanation E-12 How to Press the Shutter How to Use the Zoom Lever How to Use the Mode Dial Mode dial knob E-13 Setting the Zoom Lever How to switch the power ON C-760 Ultra Zoom E-14 C-770 Ultra Zoom Page E-16 Removing the TLL cable connector cap ---- How to attach the TTL cable connector cap to the case ---- E-17 Removing the hot shoe cable cap 1 3 Cleaning the TTL connector E-18 2. Advance Check of the Case Advance test before use Advance Test E-19 3. Install the digital camera. E-20 Check the operation of the camera. Load the digital camera. Open the Case. Pull up the mode dial of the case. E-21 Insertion of silica gel Set the mode dial. E-22 Seal the Case. Install the special balance weight. Check the loading status. E-23 E-24 E-25 Final Test E-26 4. Taking Pictures Under Water How to Use the Hand Strap Take pictures carefully. Confirm the picture on the LCD monitor. Quietly press the shutter lever. E-27 5. Handling After Shooting Wipe off any waterdrop. E-28 Take out the digital camera. E-29 Wash the Case with pure water. Dry the Case. E-30 6. Maintaining the Waterproof Function Remove the O-ring. Remove any sand, dirt, etc. E-31 E-32 Install the O-ring. How to Apply Grease to the O-ring E-33 Maintenance of the threaded sections on the TTL cable and TTL cable connector Maintenance of the TTL Connector Cap E-34 Replace consumable products. 1 2 E-35 7. Appendix Q & A on the use of the PT-022 E-36 E-37 E-38 E-39 E-40 After-sale Service E-41 Specifications Diver's Insurance Guide