Olympus PT-022 E-19, 3. Install the digital camera.

E-193. Install the digital camera.

Check the digital camera.

Check the digital camera before loading it in the Case.

Battery Confirmation

As the LCD monitor is used for picture confirmation while taking

pictures under water, the battery life becomes short.

Confirm that the remaining battery capacity is sufficient.

Do not use alkaline batteries, as it is quite possible that they will

become unusable during a dive.

Confirmation of the Remaining Number of Pictures to be Taken

Confirm that the image storage has a sufficient remaining number

of pictures to be taken.

Note: •In order to avoid losing shutter chances due to an exhausted

battery, you should always replace a battery with a fully

charged battery before each dive.

Loading in the Case

Which digital cameras can be loaded?

This product (PT-022) is exclusively used for the CAMEDIA C-760

Ultra Zoom/C-770 Ultra Zoom.

Removing the carrying strap and lens cap from the digital camera

If the digital camera has a carrying strap and lens cap attached, be

sure to remove them before inserting the digital camera into the

case.

:•If the digital camera is inserted into the case without

removing the carrying strap and lens cap, the case

cannot be closed properly and water penetration may

result.

•Be careful when removing the carrying strap and lens

cap from the digital camera. Olympus will not assume

any liability for any damage that may result from

dropping the camera.

CAUTION

Contents

Main Instruction Manual PT-022 Underwater Case E-1 Introduction Please read the following items before use For safe use WARNING E-2 WARNING E-3 Batteries E-4 For Prevention of Water Leakage Accidents E-5 Handling the Product E-6 E-7 Contents Contents 1.Preparations ............................................................E-9 2.Advance Check of the Case 3.Install the digital camera. E-8 4.Taking Pictures Under Water 5.Handling After Shooting 6.Maintaining the Waterproof Function 7.Appendix Page E-10 Names of the parts Note: E-11 Install the strap. Master the basic operation. Holding the Case Installation explanation E-12 How to Press the Shutter How to Use the Zoom Lever How to Use the Mode Dial Mode dial knob E-13 Setting the Zoom Lever How to switch the power ON C-760 Ultra Zoom E-14 C-770 Ultra Zoom Page E-16 Removing the TLL cable connector cap ---- How to attach the TTL cable connector cap to the case ---- E-17 Removing the hot shoe cable cap 1 3 Cleaning the TTL connector E-18 2. Advance Check of the Case Advance test before use Advance Test E-19 3. Install the digital camera. E-20 Check the operation of the camera. Load the digital camera. Open the Case. Pull up the mode dial of the case. E-21 Insertion of silica gel Set the mode dial. E-22 Seal the Case. Install the special balance weight. Check the loading status. E-23 E-24 E-25 Final Test E-26 4. Taking Pictures Under Water How to Use the Hand Strap Take pictures carefully. Confirm the picture on the LCD monitor. Quietly press the shutter lever. E-27 5. Handling After Shooting Wipe off any waterdrop. E-28 Take out the digital camera. E-29 Wash the Case with pure water. Dry the Case. E-30 6. Maintaining the Waterproof Function Remove the O-ring. Remove any sand, dirt, etc. E-31 E-32 Install the O-ring. How to Apply Grease to the O-ring E-33 Maintenance of the threaded sections on the TTL cable and TTL cable connector Maintenance of the TTL Connector Cap E-34 Replace consumable products. 1 2 E-35 7. Appendix Q & A on the use of the PT-022 E-36 E-37 E-38 E-39 E-40 After-sale Service E-41 Specifications Diver's Insurance Guide