Olympus PT-022 E-3

E-3

Batteries

●Always use lithium ion battery packs manufactured by Olympus

and bearing the Olympus brand. For more details, refer to your

camera's instruction manual.

●Take care that the battery electrodes do not become wet. This may

cause trouble or accidents.

●Carefully read the instruction manual for the camera about other

cautions regarding batteries.

5. Jumping into the water with the Case in your pocket or in your hand,

throwing the Case from a boat or ship into the water, and other

rough handling may cause water leakage. Please handle with

sufficient care, when handing it over from hand to hand etc.

6. If the camera on the inside should become wet because of water

leakage etc., immediately wipe off all moisture and confirm the

operation.

7.Please remove the O-ring when traveling by air. Otherwise air

pressure may make it impossible to open the Case.

8. For safe use of the digital camera in this product, please read the

"Instruction Manual" for the digital camera carefully.

9.When sealing this product, take sufficient care that no foreign

matter gets caught at the O-ring and the contact surfaces.

Contents

Main Instruction Manual PT-022 Underwater Case E-1 Introduction Please read the following items before use For safe use WARNING E-2 WARNING E-3 Batteries E-4 For Prevention of Water Leakage Accidents E-5 Handling the Product E-6 E-7 Contents Contents 1.Preparations ............................................................E-9 2.Advance Check of the Case 3.Install the digital camera. E-8 4.Taking Pictures Under Water 5.Handling After Shooting 6.Maintaining the Waterproof Function 7.Appendix Page E-10 Names of the parts Note: E-11 Install the strap. Master the basic operation. Holding the Case Installation explanation E-12 How to Press the Shutter How to Use the Zoom Lever How to Use the Mode Dial Mode dial knob E-13 Setting the Zoom Lever How to switch the power ON C-760 Ultra Zoom E-14 C-770 Ultra Zoom Page E-16 Removing the TLL cable connector cap ---- How to attach the TTL cable connector cap to the case ---- E-17 Removing the hot shoe cable cap 1 3 Cleaning the TTL connector E-18 2. Advance Check of the Case Advance test before use Advance Test E-19 3. Install the digital camera. E-20 Check the operation of the camera. Load the digital camera. Open the Case. Pull up the mode dial of the case. E-21 Insertion of silica gel Set the mode dial. E-22 Seal the Case. Install the special balance weight. Check the loading status. E-23 E-24 E-25 Final Test E-26 4. Taking Pictures Under Water How to Use the Hand Strap Take pictures carefully. Confirm the picture on the LCD monitor. Quietly press the shutter lever. E-27 5. Handling After Shooting Wipe off any waterdrop. E-28 Take out the digital camera. E-29 Wash the Case with pure water. Dry the Case. E-30 6. Maintaining the Waterproof Function Remove the O-ring. Remove any sand, dirt, etc. E-31 E-32 Install the O-ring. How to Apply Grease to the O-ring E-33 Maintenance of the threaded sections on the TTL cable and TTL cable connector Maintenance of the TTL Connector Cap E-34 Replace consumable products. 1 2 E-35 7. Appendix Q & A on the use of the PT-022 E-36 E-37 E-38 E-39 E-40 After-sale Service E-41 Specifications Diver's Insurance Guide