Olympus PT-022 E-17

E-17

Removing the hot shoe cable cap

To perform TTL flash shooting when this case is used, connect the

hot shoe cable provided with the optional PFL-01 between the

connector on this case and the C-770 Ultra Zoom's hot shoe.

1Turn the hot shoe cable connector cap inside

the case counterclockwise to remove it.

2

Insert the connector of the hot shoe cable into

the case's connector and turn the connector

screws all the way clockwise to connect them

firmly.

3Insert the cable's hot shoe into the C-770 Ultra

Zoom's hot shoe.

4

When not using the hot shoe cable, attach the

hot shoe cable cap to the hot shoe cable

connector inside the case and turn the cap all

the way clockwise to attach it firmly.

:•

Be sure to remove the camera from the case when

inserting the connector of the hot shoe cable into the

case’s connector.

CAUTION

Cleaning the TTL connector

If the threaded sections of the TTL cable and TTL cable connector

stick to each other, the cable may disconnect from the connector. To

prevent this, apply O-ring silicon grease (provided with this case) to

the threaded sections.

For details, see the maintenance description on page E-33 of this

manual.

:•

If you cannot disconnect the TTL cable, do not use

force to disconnect it. Contact Olympus for support.

CAUTION

Contents

Main Instruction Manual PT-022 Underwater Case E-1 Introduction Please read the following items before use For safe use WARNING E-2 WARNING E-3 Batteries E-4 For Prevention of Water Leakage Accidents E-5 Handling the Product E-6 E-7 Contents Contents 1.Preparations ............................................................E-9 2.Advance Check of the Case 3.Install the digital camera. E-8 4.Taking Pictures Under Water 5.Handling After Shooting 6.Maintaining the Waterproof Function 7.Appendix Page E-10 Names of the parts Note: E-11 Install the strap. Master the basic operation. Holding the Case Installation explanation E-12 How to Press the Shutter How to Use the Zoom Lever How to Use the Mode Dial Mode dial knob E-13 Setting the Zoom Lever How to switch the power ON C-760 Ultra Zoom E-14 C-770 Ultra Zoom Page E-16 Removing the TLL cable connector cap ---- How to attach the TTL cable connector cap to the case ---- E-17 Removing the hot shoe cable cap 1 3 Cleaning the TTL connector E-18 2. Advance Check of the Case Advance test before use Advance Test E-19 3. Install the digital camera. E-20 Check the operation of the camera. Load the digital camera. Open the Case. Pull up the mode dial of the case. E-21 Insertion of silica gel Set the mode dial. E-22 Seal the Case. Install the special balance weight. Check the loading status. E-23 E-24 E-25 Final Test E-26 4. Taking Pictures Under Water How to Use the Hand Strap Take pictures carefully. Confirm the picture on the LCD monitor. Quietly press the shutter lever. E-27 5. Handling After Shooting Wipe off any waterdrop. E-28 Take out the digital camera. E-29 Wash the Case with pure water. Dry the Case. E-30 6. Maintaining the Waterproof Function Remove the O-ring. Remove any sand, dirt, etc. E-31 E-32 Install the O-ring. How to Apply Grease to the O-ring E-33 Maintenance of the threaded sections on the TTL cable and TTL cable connector Maintenance of the TTL Connector Cap E-34 Replace consumable products. 1 2 E-35 7. Appendix Q & A on the use of the PT-022 E-36 E-37 E-38 E-39 E-40 After-sale Service E-41 Specifications Diver's Insurance Guide