E-22

Install the special balance weight.

Seal the Case.

Check the loading status.

:•Seal the Case by turning both buckle lock levers
down in arrow direction. When one of the buckles is
left open, the Case will not be sealed and water
leakage will be caused.
CAUTION
When the rear lid is closed
(quietly, so that the O-ring will
not come out of the groove),
the buckles are engaged with
the edge of the rear lid, and the
buckle lock levers are pushed
down in arrow direction, the
Case will be sealed airtight.
Install the special balance weight to
the tripod mounting thread at the
bottom of the case. Install the balance
weight securely by tightening the
accessory screw of the balance
weight.
Always perform the following final checks before sealing the Case.
Has the digital camera been loaded so that the zoom lever
operates properly?
Has the silica gel been inserted all the way at the specified position?
Has the O-ring at the Case opening part been installed properly?
Are the O-ring and the O-ring contact surface on the front lid free of
dirt and other foreign matter?