Removing/attaching the standard port

When using the case with the separately available Wide Port for the PT-020/027 (PPO-02), the standard port attached to the PT-020 or PT-027 should be removed. To remove or reattach, use the following procedures.

Removing

1Wipe off any water drops, making sure the case is completely dry. Slowly rotate each of the two buckles on the left and right of the standard port (from the bottom toward the top as indicated by the arrow in the figure on the right).

2When the two buckles have been turned by about 110 degrees, the standard port begins to separate from the case.

3Continue turning the buckles slowly until the standard port separates completely from the case.

Buckle

Attaching

1

Align the cam grooves of the buckles on the left

Buckle cam

and right of the standard port with the bosses on

groove

 

the case.

Boss

2Fit the bosses into the left and right buckles andfit the standard port into the case while slowly turning the buckles clockwise.

3

Turn the two buckles clockwise until they stop to secure the standard port.

CAUTION : • If the standard port is attached improperly to the case, water penetration may result. Also make sure that the buckles on the left and right of the standard port are clamped firmly. Confirm indications “OPEN” and “LOCK” on the buckle when removing and reattaching the port.

❈For detailed handling of the separately available Wide Port for the PT- 020/PT-027 (PPO-02), refer to the Wide Port’s instruction manual.

E-14