Removing the hot shoe cable cap

When using this case in TTL flash shooting, the hot shoe cable provided with the separately available PFL-01 should be connected between the connector on the case and the camera’s hot shoe.

1

Turn the hot shoe cable connector cap inside the case counterclockwise to remove it.

2 Insert the connector of the hot shoe cable into the case's connector and turn the connector screws all the way clockwise to connect them firmly.

3

Insert the hot shoe on the hot shoe cable into the hot shoe on the camera.

4When not using the hot shoe cable, attach the

hot shoe cable cap to the hot shoe cable connector inside the case and turn the cap all the way clockwise to attach it firmly.

CAUTION : • Be sure to remove the camera from the case when inserting the connector of the hot shoe cable into the case’s connector.

Cleaning the TTL connector

If the threaded sections of the TTL cable and TTL cable connector stick to each other, the cable may disconnect from the connector. To prevent this, apply O-ring silicon grease (provided with this case) to the threaded sections.

For details, see the maintenance description on page E-35 of this manual.

CAUTION : • If you cannot disconnect the TTL cable, do not use force to disconnect it. Contact Olympus for support.

E-16