Check the loading status.Always perform the following final checks before sealing the Case.Has the camera been inserted properly so that the zoom lever works?

Has the silica gel bag been placed in the correct position and in the proper way?

Are both the O-rings and the contact surfaces of the front lid free of dirt and other foreign matter?

Are the O-rings correctly positioned in the groove of the front and rear lids?

Is the lens port attached properly and are the buckles locked correctly?the TTL cable connector cap attached tightly?Seal the Case.

When the rear lid is closed (quietly, so that the O-ring will not come out of the groove), the buckles are engaged with the edge of the rear lid, and the buckle lock levers are pushed down in arrow direction, the Case will be sealed airtight.

CAUTION : • Seal the Case by turning both buckle lock levers down in arrow direction. When one of the buckles is left open, the Case will not be sealed and water leakage will be caused.

Install the special balance weight.

Install the special balance weight to the tripod mounting thread at the bottom of the Case. Install the balance weight securely by tightening the accessory screw of the balance weight.

E-22