Removing the TTL cable connector cap

TTL flash shooting is possible by uncapping the TTL cable connector on this case (PT-027) and connecting the FL-20 flash case (optional PFL-01) as described in the following procedure.

TTL cableRemove.1 Remove the TTL cable connector
connector capcap from this case.

2 Connect the underwater TTL cable connector, provided with the PFL-01, to the TTL cable connector on this case.

1 Turn counter clockwise.

2

Underwater

 

TTL cable

Insert into the connector.

Turn the threaded section of the connector clockwise lightly until it is stopped.

---- How to attach the TTL cable connector cap to the case ----

Make sure there is no foreign matter attached to the O-rings inside the cap and on the TTL cable connector. To secure the cap, gently turn it clockwise until it stops.

Gently turn the cap clockwise until it stops.

CapConnector
Check O-rings

Put the cap on the case.

 

CAUTION : • If the TTL cable connector cap is loose, water penetration may result. Be sure to gently turn the cap until it stops to make sure it is firmly secured.

Do not turn or tighten the TTL cable too hard. If it is too tight, it may be difficult to loosen and remove it.

❈Refer to the optional PFL-01's instruction manual for detailed instructions on using the TTL cable and hot shoe cable.

E-15