2.4 FRONT OF THE METER (Continued)
METER BUTTONS
SETPTS Button
In the run mode, press this button to sequentially recall the previous setpoint settings. After using the /T1/T2 and /DEV buttons to alter these settings as desired, press the SETPTS button to store these new values.
Unless you press the SETPTS, /T1/T2 or /DEV button within 20 seconds to store your input, the meter will scroll to setpoint 2 the return to the run mode.
If the dual relay option is not installed or if the “L.3=1” on the “LK.CF” menu, pressing the SETPTS button will display the meter's firmware version.
/T1/T2 Button
In the run mode, pressing the /T1/T2 button will scroll to show T1, T2, and
During the configuration mode or Setpoint modes, use the /T1/T2 button to change the values of the flashing digit shown on the display and/or toggle between menu choices, such as "R.1=F" or "R.1=C". When configuring your setpoint values, press the /T1/T2 button to increment the flashing digit from 0 to 9 by 1's.
/DEV Button
In the run mode press the /DEV button to display the deviation of reading from Setpoint 1.
In the configuration or setpoint modes, press the /DEV button to scroll to the next digit.
6
