Omega Engineering FP-6000 guide

.

Image 4

Omega Engineering FP-6000 manual

Contents

User’s Guide For immediate technical or application assistance Servicing North AmericaServicing Europe Table of Contents Page Important Safety Information Warranty Record Type Omega FP-6000 Series Description Chapter IntroductionTheory of Operation Location of Fitting Chapter Installation and WiringSensor Position Sensor Wiring +30 Standard Fitting Installation Hardware, Standard SensorHardware, Hot-Tap Sensor 11/4 in mm diameter drill Pipe thread sealant Tape measure Remove brass sensor nut from sensor Hot-Tap Fitting InstallationThread brass sensor nut into pipe fitting Calculating the H Dimension Wall Thickness Record your pipes H dimension for future reference Hot-Tap Sensor = 15.00 pipe wall thickness 0.10 X I.D Standard Installation Sensor flange Alignment rod Direction of flow Step Hot-Tap InstallationThread one jam nut and lower hex nut onto Make sure the bleed valve is closed full clockwise position Direction of flow Using the Hot-Tap Installation Tool Protector plate Installation tool shaft Upper hex nuts Chapter Standard Sensor RemovalHot-Tap Sensor Removal Into the port to prevent damage Cap nuts Installation tool Maintenance Chapter Maintenance and Replacement PartsReplacement Parts Rotor Replacement Procedure Dimensions Dimensions for Standard SensorsWrought Steel Pipe Per Ansi Conversion Stainless Steel Pipe Per Ansi B36.19 Mm = inches Dimensions for Hot-Tap Sensors Factors Stainless Steel GPM/HZ LPM/HZ Factors Wrought Steel Factors Plastic Pipe GPM/HZ LPM/HZ Specifications General Data Specifications WARRANTY/DISCLAIMER OMEGA…Of Course