Omega Engineering FP-6000 manual Sensor flange Alignment rod Direction of flow

4.Place the alignment rod in the hole on the sensor flange. Align the flange so rod is parallel to the process pipe.

sensor flange

alignment rod

direction of flow process pipe (top view)

The flow sensor alignment rod MUST be parallel to the process pipe as shown.

5.Thread upper hex nuts with lock-washers until they contact the sensor flange and tighten. Check for proper "H" dimension and readjust if necessary.

sensor flange

FLOW

cap nuts

upper hex nuts and lock-washers

jam nuts

5.95 in.

(151 mm)

brass sensor nut

1-1/2 in. NPT or ISO 7/1-Rc 1-1/2in.

female pipe fitting

lower

hex nuts

"H"

wall

thickness

10% of I.D.

pipe I.D.

FLOW

process pipe

9