2Using the Handheld Infrared Thermometer

2.4.1Reviewing the Last Parameters

°F

The thermometer stores the last temperature measured in the real time mode (refer to Table 2-1). This temperature can be recalled by pressing the FUNC key.

-Press the FUNC key to review the most recently stored temperature data and parameters. You may review:

MAX temperature

MIN temperature

• dIF temperature

 

Calculated values

 

AVG temperature

TC temperature

HAL temperature

• LAL temperature

Set values

 

AMB temperature

MEM location

2.4.2Reviewing Previously Stored Temperature Data (OS534E, OS523E, OS524E)

°F

You can review all 800 stored temperature values on the thermometer display using the following procedure:

1.Press and hold the FUNC key until you see the Memory Display Mode (MEM) appear.

2.Press the key to increment the memory location or press the C F key to decrement the memory location. The memory location can be from 001 to 800.

3.Press the LOCK key. The stored temperature is shown in the lower portion of the display. If there is no data stored in a memory location, the display shows “----”.

NOTE

If no keys are pressed, the thermometer goes into sleep mode in approximately 5 seconds.

2-32

Page 47
Image 47
Omega Speaker Systems OS533E, OS532E, OS524E, OS530LE, OS53xE-CF, OS534E, OS530HRE, OS523E manual Reviewing the Last Parameters