Omega Vehicle Security OM5-C Ordering Information, Model, INPUT* rms, OUTPUT* dc, OM5-IAC-1B-C

SPECIFICATIONS Typical at TA = +25°C and +5V power.

Module	OM5-IAC
Input
Signal Range	100mV to 10V rms, 0 to 5A rms
Standard Frequency Range	45Hz to 1000Hz
Extended Frequency Range	1kHz to 20kHz
Impedance	1 MΩ ±1% shunted by 100pF (-01 thru -05),
	0.05Ω ±1% (-06, -07)
Coupling	AC
Protection(1)
Continuous	480V (Peak AC & DC)
Transient	ANSI/IEEE C37.90.1-1989
Output
Signal Range	0-5V
Current Limit	8mA
Voltage Limit	±18V
Resistance	50Ω
Protection	Continuous Short to Ground
Ripple and Noise (100Khz)	0.025% Span rms
Accuracy(2)(3)
Sinusoid	±0.25% Span
50/60 Hz
45Hz to 1kHz	±0.25% Reading Additional Factor
1kHz to 20kHz	±0.75% Reading Additional Factor
Non-Sinusoid	±0.05% Reading Additional Error
Crest Factor = 1 to 2
Crest Factor = 2 to 3	±0.15% Reading Additional Error
Crest Factor = 3 to 4	±0.30% Reading Additional Error
Crest Factor = 4 to 5	±0.40% Reading Additional Error
Vs. Temperature	±100ppm/°C
Isolation (Common Mode)
Input to Output, Input to Power
Continuous	1500Vrms max
Transient	ANSI/IEEE C37.90.1-1989
Output to Power
Continuous	50Vdc max
Rejection (50-60Hz Common Mode)	100dB
Response Time (0 to 99%)	<400ms
Output Enable Control	6.0∝S @ CLOAD = 0 to 2000pF
Selection Time
Voltage
Max Logic “0”	+0.8V
Min / Max Logic “1”	+2.4V / +36V
Current, “0,1”	0.5∝A
Loop Voltage	+7.5Vdc min, +26Vdc max
Load Resistance (maximum)	(Loop Voltage - 14) / (Loop Current)
Supply Voltage	+5VDC ±5%
Current	30mA
Sensitivity	±200ppm/%
Environmental
Operating Temp. Range	-40˚ C to +85˚ C
Storage Temp. Range	-40˚ C to +85˚ C
Relative Humidity	0 to 90% noncondensing
Emissions	EN50081-1, ISM Group 1, Class A (Radiated, Conducted)
Immunity	EN50082-1, ISM Group 1, Class A (ESD, RF, EFT)
Dimensions	2.28" x 2.26" x 0.60" (58mm x 57mm x 15mm)

NOTE:

(1)Module rating only. Backpanel connector rating may differ — use the lowest of the two in accordance with required safety requirements.

(2)At standard 60Hz factory calibration. Consult factory for calibration at other frequencies.

(3)For 10-100% rated span. Add an additional 0.25% error for 0-10% Span measurements. Accuracy includes nonlinearity, hysteresis and repeatability but not source or external shunt inaccuracy (if used).

ORDERING INFORMATION

MODEL	INPUT* (rms)	OUTPUT* (dc)
OM5-IAC-100B-C	0-100mV	0-5V
OM5-IAC-1B-C	0-1V	0-5V
OM5-IAC-10B-C	0-10V	0-5V

*Modules can be ordered with other input/output ranges. Consult factory for ordering details and specifications.

9