![](/images/new-backgrounds/1276550/27655021x1.webp)
How to Take a Reading
2.Measurement is over and blood pressure values, pulse, time, and date are displayed.
When the measurement is over, a mark flashes, and the cuff deflates
automatically. Then a mark turns on and blood pressure and time are displayed alternately, and pulse rate and date are displayed alternately.
Display of measurement results | Display of pulse rate |
Alternating
display
*If a measurement cannot be made or the blood pressure values are displayed abnormally high (low), refer to Page 28.
*If the Velcro tape comes off during the measurement, wrap the wrist cuff snugly as shown in Page 10 and measure again after fastening the Velcro tape.
3.Turn off the power.
Blood pressure measurement is complete now.
Press the START/STOP button to turn off the power.
To make another measurement, repeat the procedure in Step 1 above.
*Even if you forget to turn off the power, the monitor will turn off automatically in approximately 2 minutes.
SYSmmHg
PULSE/min DIAmmHg
11