PROGRAMMING TV/VCR COMBO CONTROL
Perform the following instructions to control a TV/VCR Combo:
1. Turn on the TV/VCR Combo and insert a video
cassette.
NOTE:Please read steps 2 through 9 completely before pro-
ceeding.Highlight or write down the codes and device you
wish to program before starting step 2.
2. On the URC-8910 remote control,press and hold
SETuntil you see the display change from the cur-
rent device and time to [CODE SET].
NOTE:The device, its code,and time are examples.Your
remote control settings may be different.
NOTE:To exit programming at any time, press EXIT once or
allow 30 seconds ofinactivity to lapse.You will see [EXIT
SETUP] as the remote control returns to normal operation.
NOTE:[INVALID] means you have inadvertently pressed an
incorrect key.Note your error and cont inue programming.
3. Press SELECTonce to beg in programming. You will
see the display change to the last-selected device
and its current code (e.g.,TV and 0051)
4. Press VCRonce.You will see the display change to
[VCR]and its current code.
5. Use the Setup Codes For TV/VCR Combos(on
page2 2) to locate the ty pe of device and bran d
name.Then use the keypad to enter the first four-
digit code for your device and press SELECTonce.
For example,to enter the first Sony TV/VCR Combo
code on page 23,press 0four times and then
SELECTonce.
Ifthe code is entered correctly,you will see the
[SUCCESS]message.
NOTE:If your TV/VCR Combo has a separate TV code,you
will also need to perform step 6.
12
Producer 2002 IR Mnl 4/4/02 10:01 AM Page 12