SETTING THE CLOCK
1. On the URC-8910 remote control,press and hold
SETuntil you see the display change from the default
device and time to [CODE SET].
NOTE:Default values for device,its code, and time are
shown above.Your remote control settings may be different.
NOTE:If you wish to exit the prog ramming mode at any
time,press EXITonce. You will see an [EXIT] message as the
remote control returns to normal operation.
NOTE:If you see an [INVALID]message, you have inadver-
tently pressed an incorrect key.Simply note your error and
continue programming.
2. (x 5) Press the ▲key five times until you see the display
change to [CLOCK SET].
NOTE:If you go past [CLOCK SET],press the
▼
key one or
more times to return to it.
3. Press SELECTonce to beg in programming. You will
see the display change to the current time.
4. Press the ▲key one or more times until you see the
desired hour (a.m.or p.m.).
5. Press the ▼key one or more times until you see the
desired minute.
6. Once the time is correctly set,press SELECTonce to
accept the values.The display will confirm your
entry with [SUCCESS]and then [EXIT SETUP].
The URC-8910 remote control will return to
normal operation.
5
Producer 2002 IR Mnl 4/4/02 10:01 AM Page 5