One for All URC-8910 RE-ASSIGNING DEVICE KEYS (continued), USING KEYMOVER

RE-ASSIGNING DEVICE KEYS (continued)

To re-assign other device keys to the AUXkey,repeat steps 1 through

6 on the previous page but substitute the key sequence from the

below chart:

To Re-Assign Device Key Perform Sequence

AUX as 2nd TV key: SET*- ▼(x 7)- SELECT - TV - AUX

AUX as 2nd DVD key: SET*- ▼(x 7)- SELECT

-DVD- AUX

AUX as 2nd SAT key: SET*- ▼(x 7) - SELECT

-SAT- AUX

AUX as 2nd CD key: SET*- ▼(x 7)- SELECT

-CD- AUX

AUX as 2nd CBL key: SET*- ▼(x 7)- SELECT

-CBL- AUX

AUX as 2nd RCVR/AMP key: SET*- ▼(x 7)- SELECT- RCVR/AMP - AUX

*NOTE:Press and hold SET(see step 1 on previous page).

You can also re-assign another unused device key by substituting an

open key for the AUX key in the above chart and performing the

sequence.For example,to re-assign an unused SAT key as a second

CDkey, per form SET*- ▼(x 7) - SELECT - CD - SAT.

USING KEYMOVER

The URC-8910 remote control includes a Keymoverfe ature that

allows you to map (or copy) keys from one mode (i.e.,source mode)

to another mode (i.e.,destination mode).

NOTE:The following keys cannot be used as a source or destination:TV,VCR,

DVD,AUX,SAT,CBL,RCVR/AMP,CD,HOMETHEATER,and SET.

For example,if your VCR does not have volume control,try mapping

the volume and mute keys from TVmode to VCRmode as follows:

1. On the URC-8910 remote control,press and hold

SETuntil you see the display change from the cur-

rent device and time to [CODE SET].

NOTE:The device, its code,and time are examples.Your

remote control settings may be different.

NOTE:To exit programming at any time, press EXIT once or

allow 30 seconds ofinactivity to lapse.You will see [EXIT

SETUP] as the remote control returns to normal operation.

NOTE:[INVALID] means you have inadvertently pressed an

incorrect key.Note your error and cont inue programming.

2. (x 8) Press the ▼key eight times until you see the display

change to [KEYMOVER].

Producer 2002 IR Mnl 4/4/02 10:01 AM Page 38