
The URC-8910 remote control includes an Operation Resetprogram
that you can use to restore the unit to factory default settings.
IMPORTANT:Executing this program will erase all custom settings,
including Home Theater assignments,Macros,Learned Keys, Keymoved
Keys,and all device assignments.
1. On the URC-8910 remote control,press and hold
SETuntil you see the display change from the cur-
rent device and time to [CODE SET].
NOTE:The device, its code,and time are examples.Your
remote control settings may be different.
NOTE:To exit programming at any time, press EXIT once or
allow 30 seconds ofinactivity to lapse.You will see [EXIT
SETUP] as the remote control returns to normal operation.
NOTE:[INVALID] means you have inadvertently pressed an
incorrect key.Note your error and cont inue programming.
2. (x 2) Press the ▲key twice until you see the display
change to [OPS RESET].
NOTE:If you go past [OPS RESET],press the
▼
key one or
more times to return to it.
3. Press SELECTonce to beg in programming. You will
see the display change to [CLR SETUP].
4. Press SELECTonce to start the process.You will see
the display change to [RESET RAM]as the active
memory is cleared,followed by [RESET E2] as the
preprogrammed memory is restored.
Then you will see [EXIT SETUP] as the URC-8910
remote control automatically exits the programming
mode and returns to normal operation.
37
Producer 2002 IR Mnl 4/4/02 10:02 AM Page 50