USING VOLUME LOCK
In its default (unlocked) state,the URC-8910 remote controlallows
each device to control its own volume only in its own mode (e.g.,TV
volumei n the TV mode, VCR volume in VCR mode,etc.). However,
using our Volu me L oc k feature,you can lock the volume controls for
each device to all modes (e.g.,RCVR/AMP volume in all modes).
Moreover,usi ng the Volume Unlockfeature (see the next page),
you can further customize the settings so that a device’s volume
controls are unlocked in one mode,but remain locked in all other
modes (e.g.,TV volume in t he TV mode and RCVR/AMP volume in
other modes).

Programming Volume Lock

1. On the URC-8910 remote control,press and hold
SETuntil you see the display change from the cur-
rent device and time to [CODE SET].
NOTE:The device, its code,and time are examples.Your
remote control settings may be different.
NOTE:To exit programming at any time, press EXIT once or
allow 30 seconds ofinactivity to lapse.You will see [EXIT
SETUP] as the remote control returns to normal operation.
NOTE:[INVALID] means you have inadvertently pressed an
incorrect key.Note your error and cont inue programming.
2. (x 4) Press the key four times until you see the display
change to [VOL LOCK].
NOTE:If you go past [VOL LOCK],press the
key one or
more times to return to it.
3. Press SELECTonce to beg in programming. You will
see the display change to [TO MODE].
4. Press a mode key (e.g.,RCVR/AMP) to lock a device’s
volume controls to all modes.You will see the display
change to [SUCCESS]and then [EXIT SETUP] as the
remote control automatically exits the programming
mode and returns to normal operation.
5. Ifdesired, repeat steps 1 through 4 as needed to lock
volume controls for other devices to all modes.
19
Producer 2002 IR Mnl 4/4/02 10:01 AM Page 32