TROUBLESHOOTING
PROBLEM: LCD (Liquid Crystal Display) begins to fade,does not
appear,or the LOW BATTERY ()icon appears.
SOLUTION: Replace the batteries with four (4) new AAA alkaline
batteries (see page 4).
PROBLEM: LED(red light) and IR ( ) icon blinks when you press a
key,but home entertainment device does not respond.
SOLUTION: Be sure to select the correct device key for the device you
want to control.Also,aim the URC-8910 remote control
at the device not farther than 15feet away.
PROBLEM: The URC-8910 remote control does not control home
entertainment devices or commands do not work properly.
SOLUTION: Try all listed codes for the device brands being set up.
Make sure they originall y can be operated with an
infrared remote control.
PROBLEM: TV/VCR combo does not respond properly.
SOLUTION: Use the VCR codes for your brand.Some combo units may
require both a TV code and a VCR code for full operation.
PROBLEM: The URC-8910remote control does not turn on Sony or
Sharp TV/VCR Combo.
SOLUTION: For Power On,these products require programming TV
codes.For Sony, use TV code 0000 and VCR code 0032.
For Sharp,use TV code 0093 and VCR code 0048.
PROBLEM: Changing channels does not work properly.
SOLUTION: Iforiginal remote control required pressing ENTER to
change channels,press ENTER on the URC-8910 remote
control after entering the channel number.
PROBLEM: During learning,the display shows an [ERROR]message
after pressing and holding a key to be learned.
SOLUTION: A bad capture has occurred.Avoid high-ambient light
sources,such as direct daylight and fluorescent bulbs.
Also,tr y readjust ing positi ons of remote controls before
performing the procedure again.Make sure the key(s)
on the original remote control is (are) operating correctly.
PROBLEM: CH+and CH- do not work for your RCA TV.
SOLUTION: Due to RCA design (1983-1987),only the original remote
control will operate these functions.
PROBLEM: No remote control ofvolume.
SOLUTION: See Using Volume Lockon page 32 to lock/unlock the
volume controls.
PROBLEM: The URC-8910remote control turns on audio devices and
controls volume,but does not change preset channels.
SOLUTION: Some products may need both a Tuner/Receiver code
and an Audio Amplifier code for remote control ofall
features on your audio device.
39
Producer 2002 IR Mnl 4/4/02 10:02 AM Page 52