Onkyo CR-525, CR-325 Setting the Clock, Press the Timer button When you’ve selected the station

Setting the Clock

Setting AccuClock to Use a Specific Station (European models only)

The AccuClock function normally uses the FM station with the strongest signal to set the clock. However, if the clock cannot be set properly using that station, you can specify which FM station the AccuClock function should use. This must be an FM station that supports RDS CT (Clock Time) information.

1		Press the [TIMER] button.	5	When you’ve selected the station,
		“Clock” appears on the display.		press [ENTER].
	Remote			While the clock is being set, “Wait”
	controller If the clock has already been set, a timer
				flashes on the display. It may take a few
		option appears instead, in which case
				minutes to set the clock. When the clock
		you’ll need to press the [TIMER] button
				has been set, the message “Clock
		repeatedly until “Clock” appears.
				Adjusted” scrolls across the display, then
				the day and time are displayed for a
2		Press [ENTER].
				while.
		“AccuClock”or “*AccuClock*” appears		Notes:
		on the display.		• If the clock is not set correctly, specify
		If “ManualAdjust” appears, use the Pre-		another FM station and try again or set
		vious and Next [7]/[6] buttons to		the clock manually (see page 50).
				• The AccuClock function automati-
		select “AccuClock” or “*AccuClock*”.
				cally updates the clock every day. If
3		Press [ENTER].		you don’t want it to, you can turn off

The frequency flashes on the display. the AccuClock function (see page 24).

4	Use the Rewind and Fast Forward
	[5]/[4] buttons to tune into
	the FM station.

Tip:

If you press the [YES/MODE] button instead of using the Rewind and Fast For- ward [5]/[4] buttons, the CD receiver will automatically search for a suitable station.

The RDS indicator appears when tuned into a station that supports RDS.

The RDS indicator will flash while the CD receiver searches for a station and light up continuously when a station is found.

49