Onkyo DR-815 instruction manual Naming Preset Channels, Inserting a Character

Naming Preset Channels—Continued

Inserting a Character

If the unit is not in “Name In” mode, execute steps 1 and 2 in “Entering a Name,” then follow the steps below.

1 Press TUNING / repeatedly until the character following the desired point of insertion flashes.

2Turn MULTI JOG until “ ” appears, then press MULTI JOG.

3 Enter the desired character as per Steps 3 and 4 in “Entering a Name”.

To continue entering characters, follow Step 3 in “Enter- ing a Name” on the previous page. To complete the oper- ation, follow Step 5.

Erasing the Name Assigned to a Preset Channel

1Select AM or FM as the source.

2Turn MULTI JOG to select the preset channel name you wish to erase.

3Press EDIT/NO/CLEAR and turn MULTI JOG until “Name Erase?” appears in the display.

4Press YES/MODE.

“Complete” appears and the name is erased.

Inputting Characters from the Remote Controller

1

2

3

Press NAME.

Press DISPLAY repeatedly until the character type you wish to enter appears in the display.

Each press of the DISPLAY switches the type of characters.

•Inputting alphabetical characters:

Each press of a number button cycles through a few characters of the alphabets. For example, repeat-

edly pressing the 2ABC button dis- plays A→B→C→A in this order. Display the desired character, then press ENTER.

•Inputting numbers and symbols:

Pressing a number button displays the corresponding number. Each press of the >10 button or the 10/0 () button switches between the

symbols labeled on the correspond-

ing button. You can input “ → . → / → * → - →, → ! → ? → & →

’→ ( → ) ” using the >10 button, and (space) using the 10/0 but- ton. Display the desired number or symbol, then press ENTER.

Note:

You cannot input all symbols from the remote controller’s number buttons. To input symbols, use the remote control-

ler’s PRESET or to select the desired symbols.

Press NAME to complete the naming process.

	1, 4
2	2
	2, 3

51