Onkyo DR-S501 Connecting the DVD receiver, Connecting the Speaker Cables, Speaker Impedance

Connecting the DVD receiver—Continued

Connecting the Speaker Cables

1	Strip about 15 mm of insu-	15 mm
	lation from the ends of the
	speaker cables, and twist
	the bare wires tightly, as
	shown.
2	Unscrew the terminal.
3	Fully insert the bare
	wires.
4	Screw the terminal tight.

The following illustration shows which speaker should be connected to each pair of terminals.

Front right	Front left
speaker	speaker

Connecting a Powered Subwoofer

Using a suitable cable, connect the DVD receiver’s SUB- WOOFER PRE OUT to an input on your powered sub- woofer, as shown.

Powered

subwoofer

LINE INPUT

Speaker Impedance

If the impedance of any of front speakers is 4 ohms or more but less than 6, set the speaker impedance to “4:~16:”.

SPEAKER IMPEDANCE

SELECTOR

Use the SPEAKER IMPEDANCE SELEC- TOR to select speaker impedance.

4:~16::

Select if the impedance of any of speakers is 4 ohms or more but less than 6.

6:~16::

Select if the impedances of all speakers are between 6 and 16 ohms.

Note:

Change of the settings may be required for some speak- ers (see page 55).

18