Initial Setup
This section explains the settings that we recommend you to make before using the AV receiver for the very first time. A setup wizard is launched upon
The
Selecting the Language for the Onscreen Setup Menus
This step determines the language used for the onscreen setup menus. See “Language” in “OSD Setup”
(➔ page 63).
Tip
•Pressing HOME will close the setup wizard. To restart the initial setup, select “Initial Setup” in the “Hardware Setup” menu (➔ page 66).
After selecting the language for
Initial Setup
Welcome to initial setup. Have you connected all the speakers and devices?
Before starting, please connect speakers and sources.
Now, would you like to start initial setup?
1st Step : Audyssey 2EQ: Auto Setup
2nd Step : Source Connection
3rd Step : Remote Mode Setup
4th Step : Network Connection
Yes
No
HOME Exit
1 Use q/won the AV receiver or remote controller to select one of the following options, and then press
ENTER.
`Yes:
Continues to “Audyssey 2EQ: Auto Setup”.
`No:
Skips the settings and terminates the initial setup. The setup wizard goes to “Terminating the Initial Setup” (➔ page 21). You can always restart the initial setup by selecting “Initial Setup” in the “Hardware Setup” menu
(➔ page 66).
Turning On & Basic Operations
Audyssey 2EQ: Auto Setup
This step performs the automatic speaker setup.
1 Use q/wto select one of the following options, and then press ENTER.
`Do it Now:
The automatic speaker setup is performed following instructions on screen. Refer to step 2 of “Using the Automatic Speaker Setup”
(➔ page 32). When this setting is complete, the setup wizard continues to “Source Connection”.
`Do it Later:
Skips this setting.
Press ENTER and continue to “Source
Connection”.