Onkyo TX-SR603X instruction manual Using Zone, Zone 2—Continued, Notes

Zone 2—Continued

Using Zone 2

Here you can turn on Zone 2, select an input source, and adjust the volume.

To set Zone 2 to the same source as the main room, press the [ZONE 2] button repeatedly to display

“Zone 2 Sel: Source.”

3To adjust the Zone 2 volume with

1	ON	STANDBY	TV	4
			I	INPUT
	V1	V2	V3
	1	2	3	+
2	V4	MULTI CH	DVD	TV CH
	4	5	6	-
	CD	TAPE	TUNER

ZONE 2

the remote controller, press the [ZONE 2] button, and then use the [LEVEL–] and [LEVEL+] but- tons.

7	8	9
			TV VOL
+10	0	CLEAR
-- / --- 10	11	12
INPUT SELECTOR
	MACRO			1–4
1	2	3	ZONE2
	REMOTE MODE
RECEIVER	DVD	CD	HDD
TAPE/AMP
	LISTENING MODE
STEREO	SURR

LEVEL- LEVEL+

To do this on the AV receiver, press the ZONE 2 LEVEL [ ]/[ ] buttons.

If the Zone 2 receiver/integrated amp is connected to the AV receiver’s ZONE 2 LINE OUT L/R jacks, use the volume control on the receiver/integrated amp.

REPEAT	AUDIO	SUBTITLE	PLAY MODE
	DIRECT		ALLST
TEST TONE	CH SEL	LEVEL	LEVEL	3
OPEN/CLOSE VIDEO OFF
		L NIGHT	CINE FLTR

RC-623M

Note:

To control Zone 2 with the remote controller, you must press the [ZONE 2] button first.

4

ZONE 2

STANDBY

To turn off Zone 2 with the remote controller, press the [ZONE 2] button followed by the [STANDBY] button.

To do this from the AV receiver, press the [OFF] button.

1	ZONE 2	Point the remote controller at the
		AV receiver and press the

[ZONE 2] button followed by the [ON] button.

ON	This turns on Zone 2 and the AV
	receiver’s 12V TRIGGER OUT.

2To select the Zone 2 input source

Notes:

•	Only analog input sources are output by the ZONE 2
	LINE OUT and ZONE 2 SPEAKERS terminals. Dig-
	ital input sources are not output. If no sound is heard
	when an input source is selected, check if it’s con-
	nected to an analog input.
• While Zone 2 is being used, listening modes that need
	surround back speakers (i.e., Dolby Digital EX and
	DTS-ES) are unavailable.
•	While Zone 2 is on,	functions will not work.

ZONE 2

with the remote controller, press the [ZONE 2] button followed by an input selector button.

If you select AM or FM, you can use the remote controller’s [TUNER] but- ton to select the band.

To perform steps 1 and 2 on the AV receiver, press the [ZONE 2] button followed by an input selector button within eight sec- onds.

The name of the selected Zone 2 source appears on the display.

• You can’t select different radio stations for Zone 2 and

the main room. For example, if you have an FM sta-

tion for the main room, that station will also be used

in Zone 2.

76