Others
The sound changes when I connect my head- phones?
•When a pair of headphones is connected, the listening mode is set to Stereo, unless it’s already set to Stereo or Direct. When you disconnect the headphones, the previous listening mode will be resumed.
The speaker volume cannot be set as required?
•When the Automatic Speaker Setup function is used, or the volume is adjusted on the onscreen setup menus, the maximum possible volume setting may change.
The speaker distance cannot be set as required?
•In some cases, corrected values suitable for home the- ater use may be set automatically.
The display doesn’t work?
•Actions are not displayed on the TV or projector that’s connected to the COMPONENT VIDEO OUT.
How do I change the language of a multiplex source?
•Use the “a. Multiplex” setting on the “4. Audio Adjust” menu to select Main or Sub (page 69).
The functions Auto Power On/Standby and Direct Change don’t work for components con-
nected via ?
• These functions don’t work when Zone 2 is turned on.
The AV receiver contains a microcomputer for signal pro- cessing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.
Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit’s malfunction. Before you record important data, make sure that the material will be recorded cor- rectly.
Resetting the AV receiver to its factory defaults
To reset the AV receiver to its factory defaults, turn it on and, while holding down the [VIDEO 1] button, press the [STANDBY/ON] button. “CLEAR” will appear on the display and the AV receiver will enter Standby mode.
The AV receiver uses a
Before disconnecting the power cord from the wall out- let, set the AV receiver to Standby.
87