Onkyo TX-SR701E, TX-SR601E Connecting speakers, Connecting the speaker cable

Connecting speakers

Front right	Center	Front left
speaker	speaker	speaker

		ANTENNA	AM
COMPONENT VIDEO
INPUT 2	INPUT 1	OUTPUT
		Y
		PB

FM 75		CAUTION: SPEAKER IMPEDANCE
			6 OHMS MIN. /SPEAKER
	ZONE 2	FRONT	SURROUND	CENTER
	SPEAKERS	SPEAKERS	SPEAKERS	SPEAKER
ZONE 2	L		L	AC OUTLETS

LINE OUT

L

			PR
	DIGITAL		COAXIAL
	IN	OUT
OPTICAL		OPTICAL
2	1
			IN
			COAXIAL
IN	IN	OUT	IN
GND
L
R
PHONO	CD	TAPE

R

VIDEO 3	VIDEO 2		VIDEO 1
IN	OUT	IN	OUT	IN
IN	OUT	IN	OUT	IN
VIDEO 3	VIDEO 2		VIDEO 1

Surround right speaker

		REMOTE		R	R
		CONTROL
DVD	MONITOR	ZONE 2
IN	OUT
			12V			SURROUND
		V	TRIGGER
			OUT	ZONE 2	FRONT SURR CENTER SURR BACK	BACK
					(SB)	SPEAKER
				L	L	AC 230-240V 50 Hz
		S	IR IN			SWITCHED
						TOTAL 100W MAX.
				PRE OUT
				R	R
						AV RECEIVER
FRONT	SURR	CENTER			SUB	MODEL NO. TX-SR701E
	L				WOOFER

R

SUB

WOOFER

DVD

Subwoofer		Surround
		left
	Surround
		speaker
	back
	speaker

Connecting speakers

After determining the layout of your speaker system, it is now necessary to connect the speakers correctly to your TX-SR701/ 701E/601/601E.

Caution:

•Be sure to connect the positive (+) and negative (–) cables for the speakers properly. If they are mixed up, the left and right signals will be reversed and the audio will sound unnatural.

•Do not connect more than one speaker cable to one speaker terminal. Doing so may damage the TX-SR701/701E/601/ 601E.

•Connect only speakers with an impedance between 6 and 16 Ω to the TX-SR701/701E/601/601E. Connecting speakers with an impedance lower than 6 Ω may damage the amplifier.

•Even if you are using only one speaker or listening to monaural (mono) sound, never connect a single speaker in parallel to both the right and left-channel terminals.

SPEAKERS			SPEAKERS
–	+		–	+
L		L	L	L
R		R	R	R
–	+		–	+

•To prevent damage to circuitry, never short-circuit the positive

(+) and negative (–) speaker wires.

NO!

Connecting the speaker cable

1. Strip away approx. 5/8 inch (15 mm) 5/8"

of the wire insulation. (15mm)

2.Twist the wire ends tightly together.

3.Unscrew the speaker terminal cap.

4. Insert the exposed wire end.

5. Screw down the speaker terminal cap.

27