Supplied accessories
Check that the following accessories are supplied with the
The following accessories may be available depending on the area which it was purchased.
AM loop antenna ⋅ 1
Remote controller ⋅ 1
Batteries (AA, R6) ⋅ 2
FM indoor antenna ⋅ 1
Front Left | Front Left | Left | Left | Front Right | Front Right | Right | Right | Surround Left | Surround Left | Surround Right | Surround Right | Center | Center | Surround Back Left | Surround Back Left | Zone 2 | Left | Zone 2 | Left | Surround Back Right | Surround Back Right | Zone 2 | Right | Zone 2 | Right | ||||
Front Left | Front Left | Left | Left | Front Right | Front Right | Right | Right | Surround Left | Surround Left | Surround Right | Surround Right | Center | Center | Surround Back Left | Surround Back Left | Zone 2 | Left | Zone 2 | Left | Surround Back Right | Surround Back Right | Zone 2 | Right | Zone 2 | Right | ||||
|
|
|
| 1 |
|
|
|
| 2 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 3 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Speaker Cable |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
Speaker cable label ⋅ 1
Conversion plug ⋅ 1
(Use this plug if the power cord plug of the TX- SR701/701E/601/601E does not fit your AC outlet. Shape may vary depending on the area which it was purchased.)
75/300 Ω antenna adapter ⋅ 1
Before using this unit
Setting the voltage selector (Worldwide models only)
Worldwide models are equipped with a voltage selector so that you can set your
Determine the proper voltage for your area:
ANTENNA | AM | FM 75 | CAUTION: SPEAKER IMPEDANCE |
6 OHMS MIN. /SPEAKER |
COMPONENT VIDEO | ZONE 2 | FRONT | SURROUND | CENTER | ||
INPUT 2 | INPUT 1 | OUTPUT | SPEAKERS | SPEAKERS | SPEAKERS | SPEAKER |
Y | ZONE 2 |
| L | L | AC OUTLETS |
| LINE OUT |
|
|
|
|
PB | L |
|
|
|
|
PR | R | REMOTE | R | R |
|
|
| CONTROL |
|
|
|
| DIGITAL | VIDEO 3 | VIDEO 2 | VIDEO 1 | DVD | MONITOR |
|
|
|
|
|
|
|
|
|
| |
| IN | COAXIAL | IN | IN | IN | IN | OUT |
| ZONE 2 |
|
|
|
|
|
|
|
|
2 OPTICAL 1 | OPTICAL |
|
|
|
|
|
| 12V |
|
|
|
|
|
| SURROUND |
| |
|
|
|
|
|
|
|
| V | OUT |
| ZONE 2 | FRONT | SURR | CENTER | SURR BACK | BACK |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| (SB) | SPEAKER | SWITCHED |
|
|
|
|
|
|
|
| S | IR IN |
|
| L |
|
| L |
| TOTAL 100W MAX. |
|
|
|
|
|
|
|
| AV RECEIVER | PRE OUT |
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
| MODEL NO. |
|
|
|
|
| 120V | |
|
| IN |
|
|
|
|
|
|
|
|
| R |
|
| R | ||
|
| COAXIAL |
|
|
|
|
|
|
|
|
|
|
| VOLTAGE | |||
IN | IN | IN | IN | IN | IN | FRONT | SURR | CENTER | 120V |
|
| SUB |
|
| SELECTOR | ||
GND |
|
|
|
|
| L |
|
|
|
|
| WOOFER |
|
| |||
L |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
R |
|
|
|
| VOLTAGE |
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
| ||||||
PHONO | CD | TAPE | VIDEO 3 | VIDEO 2 | VIDEO 1 | R |
| SUB |
|
|
|
|
|
|
|
|
|
| DVD | WOOFER |
|
|
|
|
|
|
|
| |||||||
|
|
|
|
| SELECTOR |
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
Notes:
•Do not mix new batteries with old batteries or different kinds of batteries.
•To avoid corrosion, remove the batteries if the remote controller will not be used for a long time.
•Remove dead batteries immediately to avoid damage from corrosion. If the remote controller does not operate smoothly, remove the old batteries and replace them both with two new AA batteries.
Using the remote controller
Point the remote controller toward the remote control sensor. The STANDBY indicator lights up when the unit receives a signal from the remote controller.
Remote control sensor | |
|
STANDBY indicator
Installing the remote controller batteries
30˚ | 30˚ | Approx. 16 feet |
|
|
(5 meters)
1.Remove the battery compartment cover by pressing it and sliding it in the direction shown by the arrow below.
2.Insert two AA (R6) batteries into the battery compartment. Carefully follow the polarity diagram (positive (+) and negative
3.After the batteries are installed and seated correctly, replace the compartment cover.
1 | 2 | 3 |
SEND/LEARN indicator
Notes:
•Make sure that the remote control sensor is not subject to strong light such as direct sunlight or inverted fluorescent light for it may prevent proper operation of the remote controller.
•Using another remote controller in the same room or using the
•Do not put objects on the remote controller. Its buttons may be pressed by mistake and drain the batteries.
•Make sure the audio rack doors do not have colored glass. Placing the
•If there is any obstacle between the remote controller and the remote control sensor, the remote controller will not operate.
7
