Onkyo TX-SR601E, TX-SR701E Connecting a DVD Player with 2-Channel L/R Audio Output

Connections

Connecting a DVD Player with 2-Channel (L/R) Audio Output

				ANTENNA		AM
COMPONENT VIDEO
INPUT 2	INPUT 1	OUTPUT
			Y
			PB
			PR
IN	DIGITAL		COAXIAL	VIDEO 3	VIDEO 2
		OUT		IN	OUT	IN

OPTICAL OPTICAL

21

			IN
			COAXIAL
IN	IN	OUT	IN	IN	OUT	IN
GND
L
R
PHONO	CD		TAPE	VIDEO 3	VIDEO 2

FM 75

ZONE 2

LINE OUT

L

RREMOTE CONTROL

VIDEO 1		DVD	MONITOR	ZONE 2
OUT	IN	IN	OUT
				V	12V
					TRIGG
					OUT
				S	IR IN
OUT	IN	FRONT	SURR	CENTER
			L
			R	SUB
VIDEO 1
				WOOFER

DVD

Component video output

Video output

S video output

4. DVD player (DVD)

L (white)

Analog audio output

R (red)	Digital audio output
	(optical)

: Signal flow

4. Connecting a DVD player (DVD)

Using an RCA video cable, connect the video output jack (composite) of the DVD player to the DVD V IN jack of the TX- SR701/701E/601/601E. Or if the DVD player has an S video output jack, connect it to the DVD S IN jack with an S video cable. Or if the device has component video outputs, connect them to the COMPONENT VIDEO INPUT 1 or 2 jacks on the TX-SR701/ 701E/601/601E.

With the initial settings of the TX-SR701/701E/601/601E, the DVD input source is set for the COMPONENT VIDEO INPUT 1 jacks.

If you connect the DVD player to the COMPONENT VIDEO INPUT 2 jacks, this must be changed at “Input Setup” → “Component Video” (see page 53).

Using an RCA audio connection cable, connect the audio output jacks of the DVD player to the DVD FRONT L/R jacks of the TX- SR701/701E/601/601E. Make sure that you properly connect the left channel to the L jack and the right channel to the R jack.

If the device has a 5.1-channel output, connect the DVD FRONT L/ R, SURR L/R, CENTER, and SUBWOOFER (5.1-channel input) jacks of the TX-SR701/701E/601/601E to the 5.1-channel output jacks of the DVD player. Make sure that you properly connect the left channels to the L jacks and the right channels to the R jacks.

If the device has a digital output, connect it to either the DIGITAL IN COAXIAL jack or the DIGITAL IN OPTICAL jack of the TX- SR701/701E/601/601E depending on the type of connector on the DVD player.

With the initial settings of the TX-SR701/701E/601/601E, the DVD input source is set for digital input at the OPTICAL 1 jack (OPT 1).

If the digital connection is made at a different jack, this must be changed at “Input Setup” → “Digital Input” (see page 52).

Note:

If the DVD player has both 5.1-channel audio outputs and 2- channel audio outputs, and you want to connect the DVD player only using the FRONT L/R jacks on the TX-SR701/701E/601/ 601E, use the 2-channel audio output jacks on the DVD player.

18