Onkyo TX-SR800 Miscellaneous Connections, Connections for remote control (), Connecting the power cords from other devices

Miscellaneous Connections

Connections for remote control ()

The terminal on the TX-SR800 is for connecting other Onkyo

components equipped with the same terminal. When a

component is connected to the terminal, it can be operated by the remote controller supplied with the TX-SR800. In addition, when

you connect a component to the terminal, you can also perform the system operations given below.

Power on/ready function

When the TX-SR800 is in the standby state, if an -connected component is turned on, the TX-SR800 also turns on and the input source selected at the TX-SR800 automatically switches to that component.

Be aware that this function will not work if the power cord for the -connected component is connected to the AC OUTLET on the

TX-SR800, or if the TX-SR800 has already been turned on.

Direct change function

When the play button is pressed at an -connected component, the input source selected at the TX-SR800 automatically changes to that component.

Power off function

When the TX-SR800 is placed in the standby state, all -connected components are also automatically put into the standby state.

Also, if you press the ON button on the TX-SR800 remote controller

while the TX-SR800 is turned on, all -connected components (DVD players, CD players, MD recorders, tuners, etc.) are also turned on.

TX-SR800

connector

Ex: Onkyo CD player

connector

Ex: Onkyo cassette tape deck

To connect components using the terminal, simply connect a

remote control cable from this terminal to the terminal of the

other component. An remote control cable with a 1/8-inch (3.5-

mm)miniature two-conductor plug comes with every cassette tape deck, compact disc player, MD recorder, and DVD player that has an terminal.

•When performing operations with -connected components

using the system, do not use the remote zone (Zone 2).

•For remote control operation, the audio connection cables must also be connected.

•If a component has two terminals, you can use either one to connect to the TX-SR800. The other one can be used to daisy chain with another component.

•With Onkyo DVD players, you can enter the pre-program code so that you can operate the DVD player directly with the remote

controller without connecting the terminals (see page 65).

Connecting the power cords from other devices

The TX-SR800 is equipped with AC mains outlets for connecting the power cords from other devices so that their power is supplied through the TX-SR800. By doing this, you can leave the connected device turned on and have the STANDBY/ON button on the TX- SR800 turn on and off the device together with the TX-SR800.

The shape, number, and total capacity of the AC outlets may differ depending on the area of purchase.

Caution:

Make sure that the total capacity of the components connected to the TX-SR800 does not exceed the capacity that is printed on the rear panel (e.g., TOTAL 120W).

AC OUTLETS	AC OUTLETS
SWITCHED	AC 120V 60 Hz
TOTAL 100W MAX.	SWITCHED
	TOTAL 120W 1A MAX.

some Asian models USA and Canadian models

26