Hardware Setup
0. Hardware Setup Menu
Advanced Menu
0.Hardware Setup
1.Speaker Impedance 2.Surr Back/Zone2 3.IR IN Setup 4.AM Frequency Step
ENTERQuit:SETUP
The settings within the Hardware Setup Menu will need to be made before you use your
0-1. Speaker Impedance Sub-menu
Use this
If the impedances of all speakers are between 6 and 16 Ω, select “6 ohms.” If the impedance of even one speaker is between 4 and 6 Ω, select “4 ohms.”
Note:
Before you change this setting, be sure to first lower the volume at the
Advanced Menu
0.Hardware Setup
a.Minimum | :6 ohms |
Quit:SETUP
0-2. Surr Back/Zone 2 Sub-menu
Advanced Menu
0.Hardware Setup
a.Surr Back/Zone2 :Surr Back
a. Surr Back/Zone 2
Zone 2: Select when connecting the speakers for the remote zone (Zone 2) to the SURR BACK/ZONE 2 PRE OUT or SURR BACK/ZONE 2 SPEAKERS terminals (for using the internal amplifier for Zone 2).
Surr Back: Select when connecting the speakers for the Surround back to the SURR BACK/ZONE 2 PRE OUT or SURR BACK/ZONE 2 SPEAKERS terminals (for using the internal amplifier for the surround back speakers).
Note:
The SURR BACK/ZONE 2 PRE OUT and SURR BACK/ZONE 2 SPEAKER terminals
In order to have
When you are not using the surround back speakers in the main room and using the internal amplifier to power the speakers for the remote zone (Zone 2), set the Surr Back/Zone 2 setting to “Zone 2.” When set to “Zone 2,” the Zone 2 signals are output from the SURR BACK/ZONE 2 PRE OUT and SURR BACK/ZONE 2 SPEAKER terminals. Connect the remote zone (Zone 2) speakers to the SURR BACK/ZONE 2 SPEAKER terminals or to the speakers terminals of the power amplifier connected to the SURR BACK/ZONE 2 PRE OUT terminals.
At this time, the main room is switched to 5.1 channel playback mode, and therefore you cannot select the THX Surround EX or
41