Oregon HT255 instruction manual Worn cutting blades

	OREGON® CORDLESS TOOL SYSTEM
TROUBLESHOOTING
	HEDGE TRIMMER MODEL HT255

SYMPTOM	POSSIBLE CAUSE	RECOMMENDED ACTIONS
	Cutting blades are dull	Have the cutting blades professionally sharpened.
	Worn cutting blades	Have the cutting blades replaced at an approved
		service location.
	Bent cutting blades	Have the cutting blades replaced at an approved
		service location.
	Improper cutting	Follow guidelines in “Basic cutting”.
Low cut time per	technique
battery charge
	Higher cutting speed	Apply less pressure to the throttle trigger.
	than necessary
	Resin buildup
	preventing cutting	See “Blade care”.
	blade movement
	Battery pack not fully	See “Charging the battery pack”.
	charged
		1. Make sure the charger cord is connected to both
	Charger short circuit,	the charger and the electrical outlet.
Blinking orange	charger over current,	2. Make sure the charger is receiving the correct
	over voltage limit, open	voltage.
light on charge
	circuit on battery pack,	3. Try charging another battery pack designed for
state indicator
	or charge/pre-charge	this charger.
	time out error	If this does not correct the problem, have the
		function checked at an approved service location.

24 AD 0213 - F/N 558936