Basic Steps to Install
1.Connect the output plug of the mains adaptor to the 
socket on the back of the base unit and the mains adaptor to the wall mains supply.
2.Insert the 2 rechargeable
3.Slide the battery door firmly into place.
4.Place the handset on the base unit and let the batteries charge for a full 24 hours before using for first time.
5.Connect the telephone lead to the 
socket on the back of the base unit and to the wall phone socket.
6.Align the belt clip with the holes on the both sides of the handset and click into place.
CAUTION
Use only the mains adaptor supplied with this telephone. Incorrect adaptor polarity or voltage can seriously damage the unit.
Adaptor Model No.:
Input: 230 VAC 50 Hz
Output: 9 VDC 300 mA
Battery Level Indication
The Battery icon is always displayed when the handset is on. When charging, the battery icon will be scrolling to indicate that the batteries are being charged. When fully charged, four bars are displayed. The scrolling will stop.
When an empty battery icon is displayed, place the handset on the base cradle to recharge the batteries. If low battery level happens during off- hook, a series of short beeps will be heard from the speaker of the handset.
Charging the Handset
When the handset is placed on the base cradle to charge the handset batteries, a charging tone, if set to ON, will be emitted from the handset’s speaker. (Refer to Alert Tone Section). During charging, the charge LED on the base unit will be steadily lit. The battery icon will be scrolling to indicate that the batteries are being charged.
Get into the habit of putting the handset on the base unit to charge when it is not in use to ensure the handset is always fully charged.
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. Never use
11 of 72 | 12 of 72 |
