OTC Wireless Selecting the Serial Mode for WiSER2400.Plus, Status LEDs, WiSER2400.IP, RS-232

1.1.4 Selecting the Serial Mode for WiSER2400.Plus

The WiSER2400.Plus has a 4-position dipswitch next to the mini Phoenix connector for selecting the serial operating mode:

RS-232

RS-485(select RS-485 and half-duplex)

RS-422(select RS-485 and full-duplex)

The factory default has the dipswitch set in the RS-232 mode. Please refer to Fig. 4 for details in setting the dipswitch for different operating modes.

1.1.5 Status LEDs

Power on the WiSER2400, the LEDs on the front panel should exhibit the following patterns:

(Refer to Fig. 3 and Fig. 4)

LED	Color	Light Blinking	Indication
		Pattern
			Proper power is
ON	RED	Steady on
			supplied
		Steady on	Unit is linked to a
			wireless system
RX	GREEN
		Steady blink	Unit is not linked to
			any wireless system
		On when	Unit is transmitting
TX	RED
		transmitting	RF signal
LINK	YELLOW	Blinking	Serial Mode

Secure the WiSER2400 at the desired location with the provided Velcro (for WiSER2400.IP) or DIN Rail mounting kit (for WiSER2400.Plus) once the hardware is setup and works properly with the intended host device or equipment.

WiSER2400.IP

Fig. 3 WiSER2400.IP

WiSER 2400 Technical Manual Version 2.16 Copyright  2001-2005, OTC Wireless, Inc. All Rights Reserved Page 7 of 32