TURBO KIT INFORMATION

The Turbo Kit is an addition that can be added to any sealed FX. It is highly recommended in hot climates or for installations that can use a few hundred watts of extra power. Typically, the Turbo Kit adds 300-500 watts of power to the FX. In hot climates or when the FX is the primary charging device, the chances of the FX overheating are heightened. When the FX gets to its temperature limits, it will back off the charging process to avoid overheating (and a shutdown of the FX). The Turbo Kit solves this problem by directing air over the casting and its fins, thus causing better convection for the FX.

The signal powering the Turbo Kit fan comes from the auxiliary output of the FX. The default setting on the auxiliary output is set to “CoolFan” which starts the Turbo Kit automatically when the FX starts heating up.

The instructions for adding a Turbo Kit are included with the Turbo Kit. If you are also automatically starting a generator using the auxiliary output, you can program the auxiliary output to “GenAlert” and parallel the generator start wires with the Turbo Kit wires. When the generator is running the Turbo Kit is also running. This may seem like a poor solution, but the FX gets hottest when it is charging. If the paralleling of the generator and the Turbo Kit doesn’t work properly, adding a 470 uF (micro Farad) electrolytic capacitor (found at your local electronics shop) across the auxiliary output will solve this problem.

Copyright 2003  OutBack Power Systems, Inc.

FX & VFX “E” Series Inverter/Charger System

Installation & Programming Manual

19009 62nd Ave NE, Arlington WA 98223 USA

 

Page 17

Tel 360 435 6030 Fax 360 435 6019

Rev 7.0 07/02/04