Basic shooting operations (continued)
Shooting in auto mode
1 Turn the POWER switch to ON. (Page 26)
•Check that the mode lamp (CAMERA) is lighted red.
2 Switch the AUTO/MANUAL switch to AUTO to select auto mode.
•
appears on the viewfinder and LCD monitor.
•The focus, shutter speed, gain, iris, and white balance are adjusted automatically. In addition, if the AUTO SW item in the setting menu SW&DISP SETUP screen is set to FACE DETECT ON, focus is automatically aligned on faces detected in the image and brightness is adjusted for optimal results.
A
appears when FACE DETECT ON is set.
•Up to 15 face detection frames can be displayed on the screen at one time. Larger frames and frames closer to the center have priority.
•When FACE FRAMING is set to ALL and multiple subjects are detected, only the frame on which focus is aligned is displayed in orange. All other frames are displayed in gray.
•Primary (priority) frames
The primary frame is displayed in orange. Focus is automatically aligned to the primary frame, and the brightness is adjusted. When you press the REC CHECK/PHOTO button halfway in PHOTO mode, focus is aligned to the primary frame.
When focus is aligned, the primary frame turns green.
3 Press the START/STOP button (Red) to start shooting.
•Press again to enter recording standby mode.
•Shooting is not possible when a menu screen is displayed. First, close the menu screen, and then press the START/STOP button.
•Shooting stops when the SD Memory Card cover is opened during shooting.
ヲヶリヱヤモヮユンャレチヴヵモヱヰヸユンンヵ ラヰ
| ヤモヮユンモ |
| ヤモヮユンモ |
1 ヲヶリ レチヴヵモンヵ | 3 ヲヶリ レチヴヵモンヵ | ||
ワチヮヰヱヰヸユン | ワチヮヰヱヰヸユン | ||
| ャ |
| ャ |
| ヱラヰヵヰ |
| ヱラヰヵヰ |
Lock release button Mode lamp | |||
ョチヰ ュユ | ョチヰ ュユ | ||
ヰ |
| ヰ |
|
2
AUTO MANUAL
•The images shot from when shooting starts until it is stopped are recorded as one clip.
•When recording is paused after a short period, a small amount of time may be required after pressing the START/STOP button to stop recording before writing to the SD Memory Card is terminated.
This means that operations cannot be accepted if the START/STOP button is pressed immediately.
•The camera will read information from the SD Memory Card immediately after the card is inserted. Press the START/STOP button to
begin recording after 
(pause) is displayed in the operation status display. (Page 87)
• The camera’s factory default setting is PH mode 1080/60i recording.
(To view current setting status: Page 45)
• The upper limit for the number of clips which can be recorded on a single SD Memory Card is 900. (However, this number may exceed 900 clips at times such as when shooting immediately after the POWER switch has been set to ON.)
34