Removing SD Memory Card
1 Slide the card cover release lever, and open the SD Memory Card cover.
•Make sure that the SD Memory Card ACCESS lamp is not flashing orange before opening the cover.
2 Press the center of the SD Memory Card so that it pops out slightly, and pull the card straight outwards.
1
SD Memory Card access lamp
2
•Do not remove the SD Memory Card or switch off the power in the following circumstances. Doing so may damage your SD Memory Card.
1)While the SD Memory Card ACCESS lamp is flashing orange after inserting an SD Memory Card.
2)While the SD Memory Card ACCESS lamp is flashing during recording, recording finalization, and other operations.
Protecting SD Memory Cards
Move the
LOCK
| |
switch | 32 |
|
Repairing SD Memory Cards
Never remove the SD Memory Card or disconnect the battery or DC cable while the SD Memory Card ACCESS lamp is flashing, as doing so may damage the SD Memory Card. In the event the SD Memory Card is removed while the SD Memory Card access lamp is flashing, or the battery or DC cable is disconnected during a recording or recording finalization process, a repair verification screen will appear the next time the power is turned on to allow errors to be repaired.
Select YES to begin repairing. When repairing is | Shooting |
Select NO to switch directly to the recording | |
complete, “REPAIR FINISHED” will be displayed, and |
|
the camera will switch to the recording paused screen. |
|
paused screen without repairing. |
|
•Memory cards cannot be repaired with the camera
if NO is selected, but can still be repaired by using the AVCCAM Restorer∗ contents repair software.
•An SD Memory Card on which an error occurred can be repaired by using either the camera that was used for the shooting, or the AVCCAM Restorer contents repair software.
•A repair confirmation message may be displayed after inserting an SD Memory Card which has no error, but repair will not be performed even when YES or NO is selected.
•Repair may take up to 20 minutes or so depending on the places where the errors occurred on the card.
•Use a battery with an adequate charge or the AC adapter.
•If the repair operation has failed, “SYSTEM ERROR TURN POWER OFF” will be displayed. In this case, please use the AVCCAM Restorer contents repair software.
Depending on the status of the data, it may not be possible to restore all data completely. In this case, it will no longer be possible to play back the clips that were recorded before the SD Memory Card was ejected or the power was turned off.
•Clips with a total recording time of less than 10 seconds may not be able to be repaired.
•Shot marks added during recording cannot be
repaired.
∗AVCCAM Restorer is included on the supplied
For details on how to use it, read the operating instructions (PDF file).
The AVCCAM Viewer can also be downloaded from the following website.
37