Panasonic AJ-D455P Displaying the Hours Meter information, Item No Description

Error messages

Displaying the “HOURS METER” information

Press the cursor buttons (, ) to move the cursor ( ∗ ).

The number for the item where the cursor is located is shown on the counter display.

Item No.	Item	Description
H00	OPERATION	Displays the time that the power has been supplied in one-hour units.
H01	DRUM RUN	Displays the time that the drum has been rotating in one-hour units.
H02	TAPE RUN	Displays the time that the tape has been running during FF, REW, PLAY, SEARCH (JOG,
		VAR, SHTL), REC, and EDIT modes (except for STILL in the JOG, VAR or SHTL mode) in
		one-hour units.
H03	THREADING	Displays the number of times for threading/unthreading in single units.
H11	DRUM RUN r	Displays the time that the drum has been rotating in one-hour units. (Can be reset)
H12	TAPE RUN r	Displays the time that the tape has been running during FF, REW, PLAY, SEARCH (JOG,
		VAR, SHTL), REC, and EDIT modes (except for STILL in the JOG, VAR or SHTL mode) in
		one-hour units. (Can be reset)
H13	THREADING r	Displays the number of times for threading/unthreading in single units. (Can be reset)
H30	POWER ON	This displays the number of power-on times with one power-on counting as one time.

<Note>

The resettable items in the “HOURS METER” information are reset by the service personnel when performing maintenance or other work.

If T&S&M is selected in the setup menu No. 003 (DISPLAY SEL), a message appears in the mode display whenever a warning or error occurs. When multiple events occur, the event with the highest priority is displayed.

Priority	Counter display and	Description
	monitor display
High	Error messages	When an abnormal operation is detected in this machine, an error number flashes
	(See error message table)	on the counter display and an error message is displayed.
	INT SG	If “BB” or “CB” in No. 601 (INT SG) in the setup menu is selected, pressing the REC
		button (E to E mode) will display “INT SG” for the first two seconds. This is also
		displayed for the first two seconds when starting editing from the external controller.
	NO INPUT	If there is no input signal (except for analog audio) to the connector selected using
		the VIDEO INPUT switch, pressing the REC button (E to E mode) will display “NO
		INPUT” for the first two seconds. This is also displayed for the first two seconds
		when starting editing from the external controller.
	Warning messages	When a warning occurs in this unit, an error number appears at the counter display
Low	(See warning message	and warning message is displayed. When multiple warnings occur, the warning with
	table)	the highest priority is displayed.

46