Status Displays Inside the Viewfinder Screen

Display Mode and Setting Change Message

Messages informing of the contents of changed settings and adjustment results can be limited to part of the displayed items or not displayed for all items.

The conditions under which messages are displayed and the corresponding display modes are shown in the table below.

Setting change/adjustment results messages and display modes

Conditions under which

 

Display mode

Message

 

setting

 

messages are displayed

 

 

 

1

 

2

 

3

 

 

 

 

 

 

 

 

 

 

 

When the filter selection is

Filter: n (nr1, 2, 3, 4)

q

 

q

 

¿

changed.

 

 

 

 

 

 

 

 

 

 

 

 

 

When the gain setting is

GAIN: n dB (nrp3, 0, 3, 6, 9, 12, 15, 18,

q

 

q

 

¿

changed.

GAIN: 21, 24, 30, 36)

 

 

 

 

 

 

 

 

 

 

 

 

When the WHITE BAL switch

WHITE: n (nrACH, BCH, PRESET)

q

 

q

 

¿

setting is changed.

 

 

 

 

 

 

 

 

 

 

 

 

 

When the OUTPUT/AUTO

AUTO KNEE: ON (or OFF)

q

 

¿

 

¿

KNEE switch is set to AUTO

 

 

 

 

 

 

KNEE or OFFF)

 

 

 

 

 

 

 

 

 

 

 

 

 

When the shutter speed/

SS: 1/100 (or 1/120, 1/250, 1/500,

q

 

¿

 

¿

mode setting is changed.

SS: 1/1000,1/2000, S. SCAN, SUPER V)

 

 

 

 

 

 

 

 

 

 

 

 

When the white balance is

Ex.) AWB: OK

q

 

¿

 

¿

adjusted (AWB)

ÁSee “Adjusting the White Balance”

 

 

 

 

 

 

(page 70) for a detailed description.

 

 

 

 

 

 

 

 

 

 

 

 

When the black balance is

Ex.) ABB: OK

q

 

¿

 

¿

adjusted (ABB)

ÁSee “Adjusting the Black Balance”

 

 

 

 

 

 

(page 75) for a detailed description.

 

 

 

 

 

 

 

 

 

 

 

¿: Message displayed

 

q: Message not displayed

F) The message is displayed for approximately 3 seconds immediately after the power for the unit is turned on.

Note{

Whether a message is displayed or not also depends on the status of other menu settings.

For instance, even if the filter selection is set to “1”, the filter message will appear if FILTER is set to ON on the VF INDICATOR page.

– 61 –